second illumination after each button press).
5. Select filter replacement run time
The thermostat will display the Filter Alarm after a set time of operation. This
is a reminder to change or clean your air filter. This time can be set from 0 to
12 months in 1 month increments. Selection of 00 WILL CANCEL THIS
FEATURE. When Filter Alarm is displayed, you can clear it by pressing the
"F" button. (To enter filter program) and then hold the ▲ and ▼ buttons.
This resets the timer and starts counting the days until the next filter change.
6. Select ºF or ºC readout
Changes the display readout to Centigrade or Fahrenheit as required.
7. Select temperature recalibration
This feature allows you to adjust the displayed room temperature up to 4º
To Next Page
Loading...
Need help?
General
