SATEL INTEGRA Plus 7
4.2 Modules to be connected to the expander bus
INT-RX / INT-RX-S. 433 MHz keyfobs receiver expansion module. Enables operation of
the alarm system using the 433 MHz keyfobs.
INT-CR. Proximity card arm/disarm device. Enables arming / disarming and alarm clearing
in many partitions by means of proximity cards, proximity tags and other passive
transponders.
INT-S / INT-SK. Partition keypad. Enables arming / disarming and alarm clearing in one
partition. Can perform access control functions.
INT-SCR. Multifunctional keypad. It can work as:
INT-S. Partition keypad.
INT-SCR. Partition keypad with reader. Functionality similar to that of the partition
keypad.
INT-ENT. Entry keypad. The main task of the entry keypad is activation the delay for 3
I
NTERIOR DELAYED
type zones. After expiry of the time period preset on the keypad,
unless the system is disarmed, the interior delayed zones will again act as instant
ones.
INT-SZ / INT-SZK. Code lock. Enables performance of the access control functions.
INT-R. Universal expander for card / chip readers. Supports the proximity card readers
manufactured by SATEL, readers with WIEGAND 26 interface or DALLAS chip readers.
Enables performance of the access control functions.
CA-64 E Zone expander. Adds 8 programmable hardwired zones to the security system.
CA-64 EPS. Zone expander with power supply. Adds 8 programmable hardwired zones to
the security system. Equipped with a built-in switching power supply.
CA-64 ADR. Addressable zone expander. Adds 48 addressable zones to the security
system. Equipped with a built-in switching power supply. Control panels support the
addressable zone expanders with firmware version 1.5 (or later).
CA-64 O. Output expander. Adds 8 programmable outputs to the security system. Made in
three versions:
CA-64 O-OC – 8 OC type outputs;
CA-64 O-R – 8 relay outputs;
CA-64 O-ROC – 4 relay outputs / 4 OC type outputs.
INT-ORS. DIN-rail output expander. Adds 8 programmable relay outputs to the security
system. The relays can control electrical devices supplied with 230 V voltage.
CA-64 OPS. Output expander with power supply. Adds 8 programmable outputs to the
security system. Equipped with a built-in switching power supply. Made in three
versions:
CA-64 OPS-OC – 8 OC type outputs;
CA-64 OPS-R – 8 relay outputs;
CA-64 OPS-ROC – 4 relay outputs / 4 OC type outputs.
INT-IORS. DIN-rail zone/output expander. Adds 8 programmable hardwired zones and 8
programmable relay outputs to the security system. The relays can control electrical
devices supplied with 230 V voltage.
CA-64 PP. Zone/output expander with power supply. Adds 8 programmable hardwired
zones and 8 programmable outputs
(4 relay and 4 OC type)
to the security system.
Equipped with a built-in switching power supply.
ACU-100 / ACU-250. ABAX wireless system controller. Enables the alarm system to be
operated using the ABAX keyfobs and the ABAX bidirectional wireless devices to be
used in the alarm system.
To Next Page
