Satel INTEGRA 64 Plus - 3 Keypads

SATEL INTEGRA Plus 5
Programming
 Local programming:
– keypad;
– computer with the D LOAD X program installed, connected to the control panel RS-232 or
USB port.
 Remote programming:
– computer with the D LOAD X program installed, communicating via the telephone network
or via the Ethernet network (optionally, if the ETHM-1 module is connected);
– internet browser (optionally, if the ETHM-1 module is connected);
– mobile phone with suitable application installed (optionally, if the ETHM-1 module is
connected).
Mainboard
 RS-232 port (RJ type socket) to allow:
– local programming by means of a computer with the D LOAD X program installed;
– local system administration by means of a computer with the G UARD X program installed;
– remote programming using the D LOAD X program via Ethernet (TCP/IP), if the ETHM-1
module is connected;
– support for external analog, GSM or ISDN modem;
– serial printer connection (for printing current events).
 USB MINI-B socket to allow:
– local programming by means of a computer with the D LOAD X program installed;
– local system administration by means of a computer with the G UARD X program installed.
 Capability of the firmware updating without the need for disassembly of the control panel.
 2 sockets for connecting the INT-VG voice module, CA-64 SM voice synthesizers
expander or SM-2 synthesizer.
 Real time clock with calendar and battery backup.
 LEDs indicating the status of outputs, battery charging system and telephone dialer.
 Electrical protection of all hardwired zones and outputs, and communication buses.
 Built-in advanced switching power supply with separate circuits for charging the battery
and powering other devices.
3. Keypads
The INTEGRA Plus control panels support the following keypads:
INT-TSG – touchscreen keypad;
INT-TSI – touchscreen keypad;
INT-KSG – LCD keypad with touch keys;
INT-KLCD – LCD keypad with mechanical keys;
INT-KLCDR – LCD keypad with mechanical keys and built-in proximity card reader;
INT-KLCDK – LCD keypad with mechanical keys;
INT-KLCDL – LCD keypad with mechanical keys;
INT-KLCDS – LCD keypad with mechanical keys;
INT-KLFR – LCD keypad with mechanical keys and built-in proximity card reader.
The recommended version of the keypad firmware (provides functionality consistent
with the requirements of EN 50131 for Grade 3):
 INT-KLCD / INT-KLCDR – 1.12 (or later);