SATO CG4 Series - Offset Position Adjustment

Section 8: Appendix
CG4 Series Operator Manual Page 8-9
8.6 OFFSET POSITION ADJUSTMENT
This setting adjusts the option (Cutter, Dispenser, Tear off) stop position after a print out.
The Offset position can be adjusted by using SATO Utilities Tool application or by sending command <PO>
from the host. The setting range is within ±99 dots. A positive value moves the leading edge of the label
forward (away from the print head) while a negative value moves the leading edge of the label back toward
the mechanism.
-99 (dot)+99 (dot)
Label feed direction
Stop position for
cutting,dispense
or tear-off
Adjustment for
“+” direction
No
Adjustment
Adjustment for
“-” direction
Adjustment of Offset setting
Base reference
position for printing