What to do if my SATO Printer is not dispensing linerless labels?
If your SATO Printer is not dispensing linerless labels: Set Linerless (Non sepa) unit correctly Clean the Linerless platen roller.
What to do if my SATO CG4 Printer displays 'Ribbon end' error?
If your SATO Printer shows a 'Ribbon end' error, it means that the printer is either out of ribbon or the ribbon is ripped, or the ribbon is not set properly. To fix this, set the ribbon properly.
What to do if my SATO CG4 Printer is not feeding media?
To address the issue of your SATO Printer not feeding media: Set media correctly, Set the sensor correctly by Utility Tool setting Check the connection of sensor cable. Adjust sensor level Clean the platen roller.
What to do if my SATO CG4 Printer shows 'Ribbon near end'?
If your SATO Printer displays 'Ribbon near end', it indicates that there is not much ribbon left. Replace the ribbon to resolve this issue.
What to do if my SATO CG4 labels are not dispensed?
If labels are not dispensed from your SATO Printer: Set dispenser unit correctly Clean the Dispensing roller and Platen roller.
Why is my SATO CG4 printing very dark?
If your SATO Printer's print is very dark, set the print darkness.
How to resolve incorrect label sensor selection on my SATO Label Maker?
If you have incorrect label sensor selection on your SATO Label Maker, set the sensor correctly by printer setting tool.
What to do if my SATO CG4 Printer cover is open?
If you receive a 'Cover open' error on your SATO Printer, it indicates that the cover is not closed properly. Make sure to close the cover completely.
What to do if my SATO Label Maker displays ribbon near end?
If your SATO Label Maker displays a 'Ribbon near end' message, it means the remaining amount of ribbon is little, replace the ribbon.
What to do if my SATO Label Maker displays a buffer over error?
If your SATO Label Maker shows a 'Buffer over' error, it means the amount of data received exceeds the limit of the receive buffer, or the protocol is wrong. Correct the software on the host side or set the correct protocol to resolve this.
General| Print Method | Thermal transfer |
|---|---|
| Print Resolution | 203 dpi |
| Print Width | 104 mm |
| Media Type | Label, tag |
| Media Width | 25.4 mm to 114 mm |
| Media Thickness | 0.06 mm to 0.19 mm |
| Media Roll Diameter | 127 mm |
| Processor | 32-bit RISC |
| Memory | 8 MB Flash |
| Interfaces | USB, Serial |
| Optional Interfaces | Wireless |
| Power Source | 100-240 VAC, 50/60 Hz |
| Roll Core Inner Diameter | 25.4 mm |
| Operating Temperature | 5°C to 40°C |
| Storage Temperature | -20°C to 60°C |
| Print Speed | 4 ips (101.6 mm/s) |
| Ribbon Core | 25.4 mm |
| Humidity | 20% to 85% (non-condensing) |
To Next Page
