Section 8: Appendix
Page 8-8
CG4 Series Service Manual
8.2 OPTIONAL ACCESSORIES - DISPENSER (cont’d)
5.
Close the top cover until it clicks into position.
6. After turning on the label, turn on the power.
The printer is online and the
ON LINE (POWER) indicator
lights green.
When the printer is ready, press the
FEED/LINE button to
output an empty label and stop at the dispenser. This
procedure is to ensure that the label is loaded correctly.
8.2.3 Stop position Adjustment
Normally, the label is dispensed to the point where 2 or 3mm (0.08” or 0.1”) of the label remain on the liner
(backing paper).
If the label is not dispensed at the regular position, you can change the
offset setting with the SBPL
commands. Please refer to
Section 6.6 Offset position Adjustment for the detailed procedures. After
adjusting the stop position, dispense two or three labels to fix the stop position.
Notes:
• There may be cases when the dispenser does not function properly due to the thickness of the labels
used.
• The Dispenser unit is effective for label pitch 22 to 100 mm (0.86” to 3.93”). However, the label size limita-
tion may vary with application conditions.
• Labels over 100mm (3.9”) may curl at dispenser due to the nature of the material. There is no remedy for
this.
8.3 OPTIONAL ACCESSORIES - LINERLESS (NON SEPA)
8.3.1 To install the optional Linerless (Non sepa)
1.
Make sure the printer is powered off and disconnect the
power cable and interface cable.
2. From the base of the printer, remove three screws (circled)
as shown.
3. Remove the Bottom Housing cover.
CAUTION:
Ensure not to scrape the window portion when the printer
is turned over.
To Next Page
Loading...
