SATO CG4 Series - Linerless (Non Sepa) Label Sensor Replacement (Optional)

Section 7: Replacement Procedures
CG4 Series Service Manual Page 7-21
7.15 LINERLESS (NON SEPA) LABEL SENSOR REPLACEMENT (OPTIONAL)
This section covers the basic mechanical procedures for replacement of the Linerless (Non sepa) label
sensor.
1. Remove the Bottom Housing Cover as explained in the
earlier
Section 7.3 Removal of the Bottom Housing
cover
.
2. Disconnect the Linerless (Non sepa) label sensor cable
from the
OPTION connector on the MAIN PCB.
3. Turn over the printer in upright position, open the Top cover
and remove the
Linerless (Non sepa) assembly by
pushing it upward.
4. From the reverse side of the Linerless (Non sepa) assem-
bly
, remove the screw securing the Linerless (Non sepa)
label sensor holder
in place.
5. Press the tabs to release the Linerless (Non sepa) label
sensor
and remove the cable attached to the connector
6. Replace the new Linerless (Non sepa) label sensor and
follow the above steps in reverse sequence, to reassemble
the parts.
7. After replacement, perform Tear off offset position adjust-
ment. Refer to
Section 6.6 Offset position Adjustment.
CAUTION:
Ensure that no cables are pinched between parts when
you are installing the
cutter kit to the printer.
OPTION
connector
MAIN PCB
screw
Sensor holder
connector
Linerless (Non sepa)
label sensor
tabs