Section 4: Operation and Configuration
CG4 Series Service Manual Page 4-21
4.12 FACTORY CLEAR MODE
The printer has integrated counters to measure the accumulative activity of some features. These includes
head counter, cutter counter and all counter.
You have to reset the measurement of these counters to zero whenever the counterpart has been replaced.
Selection and activation of the above Factory Clear modes are as shown below.
Printer start-up
Printer statusProcedures
Off
ON LINE (POWER)
indicator
ERROR
indicator
Buzzer
One short
beep
When the desired mode
is selected, press the
FEED/LINE button for
more than 3 seconds
until the ON LINE
(POWER) and ERROR
indicators are turned off.
Then, close the top cover
to perform factory clear.
Blinking green light
Press FEED/LINE button
to start test printing.
Green light
User Test Print start
and print continuously.
Press FEED/LINE button
to pause the test printing.
Press again to resume.
User Test Print paused.
Blinking green light
4
5
OffOff
Off
Off
Off
Off
Three
long
beep
One short
beep
Red light
Off
Red light
Factory Clear Mode
With top cover open, while
pressing the FEED/LINE
button, press and release
the POWER button.
Release the FEED/LINE
button after the next
second when you hear a
short beep sound.
Press the FEED/LINE
button repeatedly to
select different factory
clear mode cyclically.
1
2
3
(The printer will cyclically advance to next mode as long as the FEED/LINE
button is held down.)
Cutter Counter Clear
All Clear
FEED/LINE
FEED/LINE
FEED/LINE
Blinking green light
Head Counter Clear
Off
Red light
Off
Blinking red light
Blinking red light
Confirmation of the
selected mode.
Completion of factory
clear execution.
Factory Test Print
mode is activated and
then paused.
Changes to green
light after closing
the top cover.
One short
beep
To Next Page
Loading...
