SATO CG4 Series - Page 60

Section 4: Operation and Configuration
Page 4-22
CG4 Series Service Manual
4.12 FACTORY CLEAR MODE (cont’d)
4.12.1 Contents of Factory Clear (Head Counter Clear)
Executing factory clear (Head counter clear) will set the following items to factory default.
4.12.2 Contents of Factory Clear (Cutter Counter Clear)
Executing factory clear (Cutter counter clear) will set the following items to factory default.
4.12.3 Contents of Factory Clear (All Clear)
Executing factory clear (All clear) will set the following items to factory default.
No. Items to be initialized Setting value
1 Head counter 1 0.0Km
2 Head counter 2 0.0Km
3 Head counter 3 0.0Km
No. Items to be initialized Setting value
1 Cutter counter 0
No. Items to be initialized Setting value
1 Head counter 1 0.0Km
2 Head counter 2 0.0Km
3 Head counter 3 0.0Km
4 Cutter counter 0
5 Offset (V, H) Vertical = 0 dot, Horizontal = 0 dot
6 Pitch Offset 0 dot
7 Cut Offset 0 dot
8 Dispensing Offset 0 dot
9 Tear-Off Offset 0 dot
10 Label Size Pitch 896 dot x Width 832 dot [203 dpi]
Pitch 1344 dot x Width 1248 dot [305 dpi]
11 Print Speed 75 mm/sec (3 Inches/sec)
12 Print Darkness 3A
13 Sensor Type Gap
14 Paper End Search Roll
15 Zero Slash Enabled
16 Proportional Pitch Enabled
17 Buzzer Enabled