SATO CG4 Series - Page 125

Section 8: Appendix
CG4 Series Service Manual Page 8-9
8.3 OPTIONAL ACCESSORIES - LINERLESS (NON SEPA) (cont’d)
4.
Turn over the printer in upright position, open the Top cover
and replace the existing
platen roller with the Linerless
platen roller
. Refer to Section 7.2 Platen Roller Replace-
ment
for detailed procedure.
5. Remove the lower front cover by lifting it upward.
6. Attach the latches of the Linerless (Non sepa) kit onto the
holes located below the two sides of platen roller of the
printer.
Close the
top cover and turn the printer over again, with
the
Main PCB is facing upward.
7. Connect the Linerless (Non sepa) kit’s cable to the
OPTION connector on the MAIN PCB.
Route the
Linerless (Non sepa) kit’s cable through the
groove (circled) of the printer as shown.
8. Assemble the Bottom Housing cover back to the printer
and secure with the three
screws removed in step 1.
CAUTION:
Ensure that no cables are pinched between parts when
you are assembling the cover.
Linerless
(Non sepa)
kit’s cable
OPTION
connector
MAIN PCB