To Next Page
J
Jacob JonesAug 28, 2025
What to do if my SATO Label Maker shows a paper end error?
- MMarcus WhitakerAug 28, 2025
If your SATO Label Maker runs out of paper, set the paper properly.
What to do if my SATO Label Maker shows a paper end error?
If your SATO Label Maker runs out of paper, set the paper properly.
What causes a 'Sensor error' on a SATO CG408TT and how do I fix it?
A 'Sensor error' on your SATO Printer can be due to a wrong sensor level, wrong sensor type, too big a value set for pitch offset, or label meandering. Adjust the level, adjust the sensor type, or set a smaller value for the pitch offset.
What to do if my SATO Printer labels are not dispensed?
If labels are not dispensed from your SATO Printer: Set dispenser unit correctly Clean the Dispensing roller and Platen roller.
What to do if my SATO CG408TT shows 'Ribbon near end'?
If your SATO Printer displays 'Ribbon near end', it indicates that there is not much ribbon left. Replace the ribbon to resolve this issue.
What to do if my SATO CG408TT Printer is not feeding media?
To address the issue of your SATO Printer not feeding media: Set media correctly, Set the sensor correctly by Utility Tool setting Check the connection of sensor cable. Adjust sensor level Clean the platen roller.
What to do if my SATO CG408TT displays 'Ribbon end' error?
If your SATO Printer shows a 'Ribbon end' error, it means that the printer is either out of ribbon or the ribbon is ripped, or the ribbon is not set properly. To fix this, set the ribbon properly.
General| Print Method | Thermal Transfer / Direct Thermal |
|---|---|
| Resolution | 203 dpi |
| Max Print Width | 104 mm |
| Memory | 8MB Flash ROM, 16MB SDRAM |
| Print Speed | 4 ips |
| Media Sensor | Reflective and Transmissive |
| Interface | USB, RS232C |
| Optional Interfaces | Ethernet |
| Media Type | Roll, Fanfold |
| Media Width | 22 mm to 118 mm |
| Media Thickness | 0.06 mm - 0.2 mm |
| Ribbon Width | 40 mm to 110 mm |
| Power Supply | AC 100-240V, 50/60 Hz |
