To Next Page
E
Eric KrauseSep 5, 2025
Why is my SATO CG412TT printing very dark?
- JjameslongSep 6, 2025
If your SATO Printer's print is very dark, set the print darkness.
Why is my SATO CG412TT printing very dark?
If your SATO Printer's print is very dark, set the print darkness.
What to do if my SATO CG412TT cover is open?
If you receive a 'Cover open' error on your SATO Printer, it indicates that the cover is not closed properly. Make sure to close the cover completely.
How to resolve incorrect label sensor selection on my SATO Label Maker?
If you have incorrect label sensor selection on your SATO Label Maker, set the sensor correctly by printer setting tool.
How to fix incorrect label sensor selection on my SATO Label Maker?
If you selected an incorrect label sensor on your SATO Label Maker, set the sensor correctly by printer setting tool.
What to do if my SATO Label Maker displays an incorrect program error?
If the SATO Label Maker has an incorrect program error, it means that the download did not complete successfully. Download again.
What to do if my SATO Label Maker displays buffer near full?
If your SATO Label Maker shows a 'Buffer near full' message, it means the free space for receive buffer is low. Pause the data transmission on the host side and wait to have enough buffer space.
What to do if my SATO Label Maker shows a sensor error?
If the SATO Label Maker shows a 'Sensor error', it might be due to a wrong sensor level, a wrong sensor type, or label meandering. Adjust the level or sensor type as needed.
What to do if my SATO Label Maker has a cutter error?
If the SATO Label Maker cutter is not working, connect the cutter unit. If the cut operation was not performed successfully, set and feed the paper again.
What to do if my SATO Label Maker displays ribbon near end?
If your SATO Label Maker displays a 'Ribbon near end' message, it means the remaining amount of ribbon is little, replace the ribbon.
What to do if my SATO Label Maker shows a download error?
If your SATO Label Maker shows a download error, it means that you downloaded wrong data. Please, download again.
General| Print Method | Thermal Transfer / Direct Thermal |
|---|---|
| Operating System Compatibility | Windows, Linux |
| Print Resolution | 305 dpi |
| Maximum Print Width | 4.1 inches (104 mm) |
| Maximum Print Length | 999 mm |
| Media Type | Roll |
| Media Width | 0.87 inches (22 mm) to 4.57 inches (116 mm) |
| Media Thickness | 0.06 mm - 0.25 mm |
| Media Roll Diameter | 127 mm (5 inches) |
| Interfaces | USB, Serial, Ethernet |
| Supported Barcode Types | QR Code |
| Power Requirements | AC 100-240V, 50/60 Hz |
| Print Speed | Up to 4 ips (100 mm/sec) |
| Ribbon Width | 1.3 inches (33 mm) to 4.5 inches (114 mm) |
