SATO CL608e - Page 15

15
SATO CL608e/CL612e Mechanical Adjustments
Notch/Gap Sensor Adjustment
The CL-608e/612e printers can position labels using either a label gap (transmissive)
or a Eye-Mark (reflective) sensor. The sensor used is selected by DSW2-2. (page 2-3)
The gap sensor position can be adjusted over a limited range.
LOOSEN ADJUSTMENT
SCREW AND REPOSITION
IN SLOT. TIGHTEN SCREW
LABEL FEED
DIRECTION
INSIDE EDGE
OF PRINTER
1" (25 mm)
Minimum
12345678901234567890123456
1
234567890123456789012345
6
1
234567890123456789012345
6
1
234567890123456789012345
6
1
234567890123456789012345
6
1
234567890123456789012345
6
12345678901234567890123456
NOTCH/GAP SENSOR
ADJUSTMENT RANGE
NOTCH/GAP LOCATIONS
(MAXIMUM & MINIMUM)
3.5" (90 mm) Maximum
.33" (9 mm) Eye-Mark
Sensor Location
(shown for ref. only)
EYE - MARK Minimum Size
.12" (3 mm) W x .24" (6 mm) L
LABEL
MINIMUM INTER-LABEL
GAP .012" (3 mm)