8
SATO CL608e/CL612e Mechanical Adjustments
Required Equipment: #2 Pozidrv Screwdriver
10mm wrench
STEP PROCEDURE
1. Connect the power cable to the printer and AC outlet. Turn the printer
ON.
2. Raise the access door and load the ribbon and label stock. Fig. 1
3. Loosen the locking screws. Fig. 9
4. Turn eccentric with wrench.
5. When the carbon ribbon moves evenly without wrinkling, tighten the
locking screws.
LOOSEN
LOCKING
SCREWS
TURN ECCENTRIC
Fig. 9
NOTE: Only do this adjustment after adjusting ribbon wind and
unwind tension.
Ribbon Roller Adjustment
To Next Page
Loading...
