Unit 2: Technical Data
CT4i Operator’s Manual
2-3
PRINT
Method
DT models: Direct Thermal only
TT models: Thermal Transfer and Direct Thermal (switchable)
Maximum Speed (selectable)
2, 3, 4, 5, 6 Inches Per Second (CT408i)
2, 3, 4 Inches Per Second (CT412i)
2, 3 Inches Per Second (CT424i)
Resolution
CT408i: 203 Dots Per Inch (8 dpmm)
CT412i: 305 Dots Per Inch (12 dpmm)
CT424i: 600 Dots Per Inch (23.6 dpmm)
Maximum Print Width 104 mm
Maximum Print Length 400 mm
SENSING
Gap Sensitivity Adjustable
Reflective Eye-Mark Sensitivity Adjustable
Head Open Fixed
Media Out Fixed (always enabled)
Ribbon Out Fixed (always enabled)
MEDIA
Width
Media Width: 1 - 4.6inches (25 - 115mm) (28 - 118mm with backing paper)
Note: For Dispensing Mode, specifications may vary depending on the requirements
Length
0.6 - 15.66 inches (15 - 397mm)
With backing paper: 0.72 - 16 inches (18 - 400mm)
Type
Direct Thermal / Thermal Transfer depending on print model (DT or TT)
Roll stock / Fan-fold
Configuration
Roll stock: Max. outer diameter: 4.4 inches (110 mm)
Wound face-out, Inner diameter of roll: 1.6 inches (40 mm)
Fanfold: Max. stack height: 4 inches (100 mm) (external supply)
Thickness 0.0032 - 0.0076 inches (0.08 - 0.19 mm)
Wind Direction Face Out
RIBBON
Width 4.44 inches (111 mm)
Length 3937 inches (100M)
Wound Face Out
Core Diameter 0.508 inches (12.7 mm)
To Next Page
Loading...
