© 2009 SATO America, Inc. All rights reserved.
4.3 Label reprint
If the last label printed has not been cleared from the printer buffer, pressing
the FEED button causes the last printed label to be reprinted.
4.4 Sending data to the printer
To print labels using data sent from a host computer or terminal:
1. Connect the host and printer serial or parallel ports together using a
correctly wired interface cable.
2. If you are using the serial port, confirm that the host and printer are using
the same communication parameters.
3. Confirm that the POWER indicator is lit and the ERROR indicator is off.
4. Send your data to the printer.
4.5 Resetting the printer
Some commands with parameters can be saved in the printer. They are in non-
volatile memory, E
2
PROM, they can be kept permanently unless they are
changed by other commands with different parameters. To reset the parameters
to factory settings, follow the procedure below.
1. Install ribbon and media.
2. Turn on the printer.
3. Press and hold the FEED button for about 30 seconds until the printer
To Next Page
Loading...
