© 2009 SATO America, Inc. All rights reserved.
2. Press the two print head releases down to unlock the print head module
and expose the ribbon supply spindles.
3. Unwrap the new ribbon and unwind 4” from the roll. The end of the
ribbon is attached to a take-up core.
4. Observe the notches on both end of the supply core and the take-up core.
These notches must fit on the corresponding nibs on both the supply and
take-up spindles.
5. Roll several turns of ribbon on the take-up core. The coated side of the
ribbon must be on the outside of the take-up roll.
6. Place the left notch of take-up core into the nib of left take-up spindle.
7. Place the right notch of take-up core into the nib of right take-up spindle.
8. Pull the ribbon on down the over the print head and insert the supply core
onto the left supply spindle, making sure the notches in the core fit over
the nibs.
9. Place the right end of the supply core into the right spindle, lining up the
notches with the spindle nibs.
Note:
Make sure the (coated) dull side of the ribbon is to the outside where it
will be in contact with the label media.
10. Turn the take-up spindle to pull the ribbon over the print head without any
slack. Check to ensure there are no ribbon wrinkles.
11. Lower the print head and press it firmly until it locks securely on both
sides.
12. Close the top cover.
13. Wait until the ERROR no more blinks and becomes OFF, press the FEED
button to feed a label or to resume printing.
To Next Page
Loading...
