SATO GL408e - 2. RFID Command Specification

20
2．RFID Command Specification
With the SATO GL4XXe, it is possible to return RFID information before writing data.
The printer supports Continuous, Tear-off, Dispenser and Cutter print mode options. Usually, writing
information to the RFID supply takes about 3 seconds to complete. Any abnormality that interrupts
the writing of information presented by RFID supply, takes about 5 seconds to show up as an error.
However, process time still varies, depending on the data size of the write information. If reading and
writing of RFID information fails due to defectiveness such as RFID supply, it takes about 10 seconds
to present as an error. Keystrokes do not register when information writing is under progress.