SATO LM412e - Printer Properties;Options

SATO CUPS Driver for Mac OS X 6-29
User Manual
S84ex/S86ex
S84ex 203 dpi
S84ex 305 dpi
S84ex 609 dpi
S86ex 203 dpi
S86ex 305 dpi
CL6NX Series
CL6NX 203 dpi
CL6NX 305 dpi
CL4NX-J Series
CL4NX-J 203 dpi
CL4NX-J 305 dpi
CL4NX-J 609 dpi
CL6NX-J Series
CL6NX-J 203 dpi
CL6NX-J 305 dpi
WS4
WS408 DT/TT
WS412 DT/TT
PW208
PW208NX
PW208mNX
1.2 Printer Properties/Options
The driver supports printer’s the following settings below. Please take note that the setting
varies depending on the printer model. For more information, refer to the printer specifications.
Property
Description
Media Size
Sets the media size. Units in inches.
B&W
Conversion
Allows user to select dither options for improved printing image quality.
The choices are:
- Dither (default) will be used for images.
- Threshold (50%) will give sharp edges for text and bar codes.
- Threshold (75%) will give sharp edges for text and bar codes, darker
than 50%.
- Threshold (25%) will give sharp edges for text and bar codes, lighter
than 50%.
Sensor Type
Specifies the selection of the transparent sensor or the
reflection sensor
Print Method
Sets the Print method/type such as Thermal Type and Direct Thermal
Type
Resolution
Sets the print density
Print Speed
Sets the print speed
Darkness Range
Sets the print darkness. The print density parameter can be specified
in six options from “A” to “F”.
Darkness Level
Sets the print darkness level. The print density level parameter can be
specified in five options from “1” to “5”
Print Mode
Sets the operation mode such as Continuous, Tear Off, Cutter and
Dispenser Operation
Cutter
Sets the cutter options. This is only applicable for printer units with
cutter. Cutter Operation Mode should also be selected to make it work
Vertical Offset
Sets the start position coordinate. Specifies the vertical start position
correction signal. Units in inches
Horizontal Offset
Sets the start position coordinate. Specifies the horizontal start position
correction signal. Units in inches