SATO PW208NX Registration Manual

1
Printer registration manual-Real-time Light for PW208NX
Before using SOS, SOS account is necessary.
Please contact nearest SATO local office or our contracted business partners.
Connect a printer to SOS
Push the power button on the control panel until the LED lights up in blue and turn on the printer.
An initial icon is displayed at the top of the printer screen, but it is not yet connected with SATO.
Please make the following settings to link the printer and use account.
*Important”
The printer firmware is old, SOS is not supported. And SOS icon is not displayed.
Firmware version 3.2.3-r2 or newer version is required.
1. Network setting.
Network requirement for SOS
In order to connect the printer to SOS using the network,
It is necessary to enable communication on the Internet with the following port numbers.
Port number:443/TCP *Outbound only
Connection method 1
Through a firewall (DNS setting required for printers)
Connection method 2
Through a proxy server (Proxy server setting described below is necessary)

SATO PW208NX Specifications

General

Print Resolution	203 dpi (8 dots/mm)
Printer Type	Thermal Transfer / Direct Thermal
Max. Print Length	39.37 inches
Media Type	Roll or Fanfold
Media Width	0.94 to 2.36 inches
Media Thickness	0.0025 to 0.0075 inches
Ribbon Length	984 feet (300 meters)
Processor	32-bit RISC CPU
Interfaces	USB, RS-232C
Operating Temperature	41 to 104°F (5 to 40°C)
Connectivity	USB
Power Supply	AC 100-240V, 50/60 Hz