①
Sensor connector
Temperature probe or temperature/humidity probe is connected.
For connecting or removing the probe, please see section 1 "Installing the
Probes and Batteries" of Chapter 3 "Getting Started."
Never rotate the sensor unit. It will cause the device to fail.
②
Wall mounting hole
③
Battery cover
*Temperature unit switch
Display of temperature unit (°C and °F) can be changed by a switch
located in a battery compartment.
°C (default) : Slide the switch to upward
°F : Slide the switch to downward
④
Hand strap mount
⑤
USB port
Use to plug in the USB cable connecting
the Datalogger and the computer.
While not being used, the dedicated USB
port cap should be in place.
In order not to lose the cap, we recommend
that you attach the dedicated hand strap to
the cap.
To Next Page
Loading...