6. Basic Operation
Let's start with an example to view data using DATALOGGER for Windows.
Tip: Make sure that the date and time have been set on the Datalogger (see
Chapter 3 “Getting Started”), and DATALOGGER for Windows has been
installed to your computer (see Chapter 4 "Installing DATALOGGER for
Windows").
6-1. Operating the Datalogger
Follow the steps below to log test data with the Datalogger.
(1) Press and hold the POWER ON/OFF key for one second or more to turn
on the unit.
The LCD turns on to indicate that the SK-L200T II or SK-L200TH II
α
is in
the measurement state for temperature or temperature and humidity,
respectively.
(2) Press the MODE key seven times to set the logging interval.
(3) The INT mark of the LCD lights. Use the
▲
or
▼
key to set the interval one
second as "00:01"
(4) Press the REC/STOP key to conrm.
To Next Page
Loading...