SATO SK-L200 II Series - Setting the Logging Interval

−51 −
Tip: You can set the logging interval from DATALOGGER for Windows. For
further information, please refer to the online Help.
(1) Press and hold the POWER ON/OFF key for one second or more to
turn on the Datalogger. The LCD turns on to indicate that the SK-L200T II
or SK-L200TH II
α
is in the measurement state for temperature or
temperature and humidity, respectively.
(2) Press the MODE key seven times.
(3) The INT mark of the LCD lights. Use the
▲
or
▼
key to set the desired
logging interval. The rst two digits represent the "minute" and last two
represent the "second."
(Example: The display of "05:00" represents ve minutes.)
(4) Press the REC/STOP key to conrm.
(5) Press the CALL/OUT key.
The SK-L200T II or SK-L200TH II
α
returns to the measurement state for
temperature or temperature and humidity, respectively.
7-3. Setting the Logging Option
There are four logging options to choose: Once (default), Repeatedly
(overwriting), Ends at... (limited amount), By pages (partitioning).