7-1. Setting the Datalogger ID
This function is used to identify multiple Dataloggers. An ID number from 1
to 9 can be assigned to each Datalogger used.
Tips: You can only set the ID from DATALOGGER for Windows. Be sure to
erase all the data stored on the Datalogger before setting. For
instructions on how to erase the data, please refer to step (9) of
Chapter 5 "Basic Operation."
* The factory default setting is OFF.
(1) Make sure that the Datalogger is connected to your computer with the
provided USB cable.
(2) Press and hold the POWER ON/OFF key for one second or more to turn
on the Datalogger. The LCD turns on to indicate that the SK-L200T II
or SK-L200TH II
α
is in the measurement state for temperature or
temperature and humidity, respectively.
(3) Start DATALOGGER for Windows
To Next Page
Loading...