(5) Press the CALL/OUT key once. The SK-L200T II or SK-L200TH II
α
returns to the measurement state for temperature or temperature and
humidity, respectively.
(6) Press and hold the REC/STOP key for two seconds or more.
The LCD goes out, and then the REC mark and the leftmost bar of the
memory indicator light up to indicate that the logging has started.
(7) Wait for three minutes, then press and hold the REC/STOP key for two
seconds or more. The logging ends and the unit returns to the measur-
ing state.
Now you have collected about 180 readings for a 3-minute measure-
ment period using the logging interval of one second.
(8) Press and hold the POWER ON/OFF key for one second or more to
turn off the unit.
Note: The logged data will not be erased even the power is turned off.
To Next Page
Loading...