SATO SK-L200 II Series - Page 20

−18 −
(9) The "hour" display ashes. Use the
▲
or
▼
key to set to "10". (For the
hour)
(10) Press the REC/STOP key to conrm the hour setting.
Note: The Datalogger uses the 24-hour clock format.
(11) The "minute" display ashes. Use the
▲
or
▼
key to set to "30". (For the
minutes)
(12) Press the REC/STOP key to conrm the minute setting. The Datalogger
starts clocking from the "00" seconds.
(13) Press the CALL/OUT key once.
Now the setting of current date and time is complete. The SK-L200T II
or SK-L200TH II
α
returns to the measurement state for temperature or
temperature and humidity, respectively.
(14) Press and hold the POWER ON/OFF key for one second or more to
turn off the unit.
Caution
Caution on Use
 ●
Be sure to observe the operating temperature range of your Datalogger.
Although the SK-L200T II Datalogger can be used for measuring low
temperatures or high temperatures with the probe with sensor cord, never