●
If the battery power becomes low (low battery state) during operation, the
datalogger automatically does the following.
①
While logging: Datalogger immediately stops logging and is powered
off. (The collected data are stored)
②
In standby for preset start: Er1 is displayed and the preset start is
canceled.
●
The unit automatically stops logging.
①
If memory becomes full in “Once” or the quantity of logging data
reaches the set end-point in “End at…” and “By page”.
②
If the battery power becomes low (low battery state) while logging.
③
If something is wrong in the connected probe.
The stop condition can be checked by clicking the “DATA” on software.
To Next Page
Loading...