・
Do not modify, forcibly pull, bend or tie the sensor cord. Placing heavy
objects on the sensor cord or heating it will also damage the cord.
・
Do not wash or wipe this unit with alcohol, thinner, or other organic
solvents. If the unit becomes dirty, wipe it with a tightly-wrung gauze or
the like that has been dipped in warm water with neutral detergent.
・
Never touch the humidity sensor (Model SK-L200TH II
α
) with bare hands.
・
If the dew point is exceeded and condensation occurs while the humidity
sensor (SK-LTH II
α
series) is being used, immediately stop using and
allow time for the sensor to dry naturally at room temperature.
・
The SK-LTH II
α
series probes are used with SK-L200TH II
α
and are not
usable with SK-L200TH II.
For repair or calibration, contact the retailer from which the Datalogger was
purchased or your nearest local sales representative.
To Next Page
Loading...