SATO SK-L200 II Series - Page 75

−73 −
・
Check the current and preset
dates and times, and correct
them as necessary.
・
Erase the data stored on the
Datalogger.
If necessary, store the data
before erasing.
・
Erase the data stored on the
Datalogger.
If necessary, store the data
before erasing.
・
Erase the data stored on the
Datalogger.
If necessary, store the data
before erasing.
・
Restart measuring within the
measuring range.
・
Restart measuring within the
measuring range.
・
The date and time chosen were
prior to the current date and time.
・
The logging operation was started
when all pages were full with data.
・
The logging operation was started
when there was data left whose
logging ended because the battery
was removed.
・
The ID was changed when there
was data on the Datalogger.
・
The logging ended because the
battery was removed.
・
The measurement exceeded the
upper threshold.
・
The measurement exceeded the
lower threshold.
E r 4
E r 5
(only By pages)
E r 7
Momery bar
ashies starting
from the left-
most bar in turn.
Hi
Lo