Bluetooth setting information print
Prints the Bluetooth setting information on the test printing.
Bluetooth setting information default
The Bluetooth setting information is defaulted by setting tool
*1 A method that connects 2 Bluetooth supported devices by establishing virtual serial port is defined.
[Supplemental explanation]
(1) The printer operates with the slave mode. Connect the printer by specifying printer's Bluetooth Device Address (BD
address) from the master.
(2) Connection may be failed when the PIN code of the master is different from the above settings. When the
connection is failed, check PIN code by test print, match the setting of the master and reconnect.
(3) When the link with Bluetooth is lost (out of area), disconnected from the printer after the supervision timeout time.
(4) The printer will be buffer over when the receive buffer is full. Please send print data while checking the receive buffer
status by sending ENQ.
8.2 Bluetooth Settings
The followings are Bluetooth setting items. These are configurable by the commands. Refer to the "Command
Specification" for more details.
(1) PIN code (alphanumeric characters and symbols (20H, 21H, 23H-7EH) 1-16 digits)
PIN code (Personal Identification Number, pass key)is an authentication password in 1-16 digits used for printer
identification. Link key will be generated automatically after PIN code authentication and pairing start in the printer.
Once the link key is generated, there is no need for PIN code authentication. The printer can be connected without
checking the PIN code during the pairing.
(2) Device name (alphanumeric characters and symbols (20H, 21H, 23H-7EH) 1-16 digits)
By setting device name, the name can be displayed at the connected device and the printer can be identified.
Note) Only the first start-up after setting this command will process the new settings for Wireless LAN
interface. Do not power off the printer when the printer is rebooted until the printer starts up normally.
To Next Page
Loading...
