SATO WS408DT - System Mode

1Introduction Printerlights
7
1.4.2 Systemmode
Thesystemmodeconsistsofstatuslightcolorcombinations.Itcontainsa
listofcommandsforyoutoselectandrun.

Toenterthesystemmodeandrunthecommand,dothefollowing:
1. Turnofftheprinter.
2. PressandholdtheFEEDbutton,andturnontheprinte r.
3. Bothstatuslightsglowsolidorangeforafewseconds.Next,theyturnto
greenshortly,andthenturntoothercolors.
4. Whenstatuslightsshowthecolorcombinationyouneed,releasethe
FEEDbuttonimmediately.
5. PresstheFEEDbuttontorunthecommand.

Thefollowingtableisthecommandlistofthesystemmode.
LED1 LED2 Command
Green Red TransmissiveSensorCalibration(Section3.1)
Green Orange ReflectiveSensorCalibration(Section3.1)
Red Red ResettingYourPrinter(Section3.3)
Red Orange Reserved
Red Green DisableCheckingRTCBatteryCharge
Orange Red Reserved
Orange Green SelfTestandDumpMode(Section3.2)

All manuals and user guides at all-guides.com