5 Troubleshooting Media issues
36
Did you use the correct media type for printing?
The media is not loaded correctly. See Section 2.3, “Loading Media” to reload
the media.
The media sensor needs to be calibrated. See Section 3.1, “Media Sensor
Calibration” to calibrate the sensor.
The media sensor is dirty. Clean the media sensor.
Nothing is printed
The media is not loaded correctly. See Section 2.3, “Loading Media” to reload
the media.
The ribbon is not loaded correctly. See Section 2.4, “Loading Ribbon” to reload
the ribbon.
The print data might not be sent successfully. Make sure the interface is set
correctly in the printer driver, and send the print data again.
The print quality is poor
The printhead is dirty. Clean the printhead.
The platen roller is dirty. Clean the platen roller.
Adjust the print darkness, or lower the print speed.
The media is incompatible for the ribbon. Use the compatible media instead.
The media is incompatible for the printer. Use Toshiba-approved media roll
instead.
To Next Page
Loading...
Need help?
General
