6 Specifications Printer
39
6 Specifications
This chapter provides specifications for the printer.
6.1 Printer
Model WS408TT
Print method Direct Thermal and Thermal Transfer
Resolution 203 dpi (8 dots/mm)
Media Alignment
Center Alignment
Operation Mode
Standard: Continuous, Tear-off
Sensor
Media Sensor
Gap Sensor (Transmissive, Fixed) Offset:
6.27mm - Factory Default Sensor
I-Mark Sensor (Reflective, Movable)
Head Open Switch
Ribbon Sensor
Print Speed
2, 3, 4, 5, 6 inches/sec
(50.8, 76.2, 101.6, 127, 152.4 mm/sec)
2 &3 ips for peel off mode
Do not set Print Speed to 4 ips or higher speed, when the peeler
module is installed and the peeler cover is open.
Print Darkness
Darkness level – PPLZ: 0 ~ 30
Default – PPLZ: SD15
Max Printable
Area
Length 999 mm x Width 108 mm
Non-Printable
Area
Pitch Direction - Top: 1 mm, Bottom: 1 mm (excluding liner)
Width Direction - Left: 1 mm, Right: 1 mm (excluding liner)
Print Ratio
Average print ratio within 15 % or less (whole print layout area)
Full width with 1mm pitch is required
Interface USB (Type A and Type B), Ethernet
On-Board
Memory
Standard Memory (Flash ROM): 16 MB
User Memory: 2 MB
Standard Memory (SDRAM): 32 MB
External Memory
USB: Max 16 GB
To Next Page
Loading...
Need help?
General
