satoh Buck S-470D - Glow Plug; Glow Signal Lamp; Speed Control Lever; Foot Throttle

GLOW SIGNAL LAMP
The glow signal lamp which indicates the heating state of the glow plug
in the combustion chamber is installed on the instrument panel. It is
easily seen from the heating condition of the glow signal lamp resistance
wire.
SPEED CONTROL lEVER
When the speed control lever is pulled fully toward the operator, the
engine speed reaches the maximum of 2,800 rpm.
The rated speed of the engine model K3B is 2,600 rpm. This engine
speed
is not only the most appropriate one to get the longest service life
from your tractor but also the most economical one. It is the best there-
fore,
to run the engine at the rate of 2,600 rpm.
FOOT SPEED CONTROL PEDAL
The foot speed control pedal is installed on the right side of the step.
When the hand throttle lever is in the idling position, the engine speed
can be controlled freely within the range by depressing the pedal.
NOTE:
__________________________________________ __
When the hand speed control lever is in a high rev. position, the foot
speed control pedal also moves into the position for those rev. When this
is done the revolution cannot be controlled by means of the foot pedal
within the range below the rev. set by hand lever.
- 11 -