-
CLEAN-UP
HYDRAULIC
OIL
FI L
TER
Remove
the
filter at the time of draining
the
transmission case oil, and
clean
the
filter.
Loosen the
two
bolts and remove the hydraulic oil filter
under
the
right
part
of
the
transmission case.
The removed oil filter should be thoroughly cleaned
in
the
detergent
solution.
If
the
filter has breaks, repair
or
replace with a new one.
After installing
the
filter, make sure
there
is
no oil leakage.
NOTES:
________________________________________
_
1.
If
the
transmission oil drained has
to
be reused, wipe clean
the
surrounding surfaces
of
the
drain plug before draining,
so
that
dust
or
dirt
will
not
get into oil.
2.
Oil
replacement should be carried
out
every
300
hours under normal
operating conditions.
If
oil deteriorates excessively, replace it earlier
than
specified.
3. For installing of
the
oil filter make sure
that
the pipe end of
the
filter
is
securely inserted into the hole beside the suction pipe, and
then
install
the
cover.
-43-
To Next Page
Loading...