satoh Buck S-470D - Engaging the Differential Lock; Rele~Sing the Differential Lock; Power Take-Off

ENGAGING THE DIFFERENTIAL LOCK
Before the tractor slips and the speed is lowered, depress the pedal with
your right foot and engage the differential lock. If the differential lock
does not engage at the first attempt, repeat the operation more forcibly.
If it still does not engage, lower the engine speed and after disengaging
the running clutch, repeat the whole operation as described above.
RELEASING THE DIFFERENTIAL LOCK
The differential lock is automatically released by the force of the spring
when you put your right foot off the pedal. However, under particular
conditions, there may be occasions when the lock does not release.
When this occurs, depress the right and left brake pedals alternately and
quickly until the lock is released. If this happens during plowing, depress
the pedal on the unplowed side and the lock will be released.
When the right and left brakes are interlocked, the lock is released by
turning the steering wheel sharply to the left and the right. When the
differential lock is not released by any of these means, reverse the tractor
a short distance.
NOTE: __________________________________________ __
Refrain from using the differential lock when running at high speed or on
the road.
POWER TAKE OFF
By operating the PTO shift lever located on the upper left of the trans-
mission case, the three PTO speeds - 544 rpm, 802 rpm, 1,314 rpm -
can be selected.
When shifting the PTO shift lever, depress the clutch pedal fully to
interrupt the power from the engine and make sure the machine is
brought to a complete halt.
First ...... 544 rpm/2,600 engine rpm
Second
..... 802 rpm/2,600 engine rpm
Third ..... 1,314 rpm/2,600 engine rpm
Standard PTO speed:
- 15-
540 rpm/2,580 engine rpm (first)
1,000 rpm/1 ,978 engine rpm (third)