Sauder 417714 - Page 18

Step
å
Fasten the PLINTHS (JJJ) and END MOLDINGS (M35)
to the OUTER ENDS (A and C). Use twenty BLACK 9/16"
LARGE HEAD SCREWS (1S).
å
NOTE: Be sure to center the END MOLDINGS (M35) over
the HALF DISKS (MMM) on the PLINTHS (JJJ).
Step 12
A
C
JJJ
JJJ
JJJ
JJJ
M35
M35
M35
M35
MMM
MMM
MMM
MMM
MMM
MMM
MMM
MMM
BLACK 9/16" LARGE HEAD SCREW
(20 used in this step)
1S
Use bottom holes
Use bottom holes
The END MOLDINGS (M35) should be
centered over the HALF DISKS (MMM).
417714 www.sauder.com/servicesPage 18