Sauder 417714 - Page 26

Step
å
Fasten the OUTER RIGHT END (A) to the TOP RIGHT
SIDE MOLDING (FFF) on the RIGHT TOP (G2). Tighten
two TWIST-LOCK® FASTENERS.
å
Fasten a SPACER (LLL) to the OUTER RIGHT END (A).
Tighten two TWIST-LOCK® FASTENERS.
Step 20
A
G2
FFF
LLL
Surface with
TWIST-LOCK
®
FASTENERS
Large hole should be located here.
Surface with
TWIST-LOCK®
FASTENERS
417714 www.sauder.com/servicesPage 26