Saia-Burgess Controls AG
User Manual Standby System │ Document 27-645 │ Edition ENG 02 │ 2017-04-26
Programming
Diagnostic
2-21
2
program in both the Primary and the Secondary devices, then the symbol names
must also be the same. This means that you cannot use the “Separate symbol
the same symbol names must be used in ToRedSymbolsPrimary.sy5 and ToRedS-
symbols are used automatically.
symbol names in ToRedSymbolsPrimary.sy5 and ToRedSymbolsSecondary.sy5,
them, which are the same in both devices.
Using the “Common Files” branch
-
the Primary or Secondary device’s “Program Files” branch. This creates a refer-
See the picture below. When you edit a Common File, it changes the code for both
devices, so both devices will need a rebuild and download.
Even though the programs are the same in both devices, there may be other
To Next Page
Loading...