SBE SB-36 OPERATION MANUAL
SERVICE MAINTENANCE
Should your SB-36 fail to perform as stated in this manual, it is
recommended that SBE be contacted in writing. SBE will either
authorize return of the unit to the factory or refer you to an authorized
SBE repair agency in your area. DO NOT SHIP EQUIPMENT
WITHOUT PRIOR WRITTEN AUTHORIZATION FROM SBE.
Your letter to SBE must include the following:
1. Model number and serial number of equipment.
2. Date of purchase of equipment.
3. Nature of trouble.
4. Cause of trouble if known.
5. Name of distributor from whom equipment was purchased.
6. Your return address.
7. Method of shipment by which the equipment should be returned.
In addition, include any information that you feel will be helpful in
locating or
correcting the problems.
PARTS ORDERING INFORMATION
When ordering replacement parts, you should direct your order to an
SBE distributor or SBE, Replacement Parts Department, 220 Airport
Boulevard, Watsonville, California 95076. Please furnish the following
information.
1. Quantity required.
2. SBE part number and description.
3. Item or symbol number obtained from parts list, schematic,
component location drawings.
4. SBE model number and serial number.
Unless specified, SBE will determine the best method of shipment for
the parts involved.
All parts will be sent C.O.D. unless ordered through an SBE distributor.
NOTE: Minimum parts billing is $2.50.
NoobowSystems Lab. Tomioka, Japan 2003 http://www.noobowsystems.com/ Page 36 / 56
To Next Page
Loading...
