13
Counting
In AUTO mode, the machine starts to count the bill automatically as it detects the existence of the bill in the
hopper. In MANUAL mode, the machine will start to count the bill only if the bills are placed into the hopper and
START key is pressed. While counting, the machine will display the number of the bills on LCD display and it
stops working when it meets the conditions described as below;
- No bills in the hopper
- Stacker is full.
- Rejecter is full.
- The number of the bills counted is the same as the batch number to be set in BATCH mode.
- Errors have occurred.
If an error is occurred during operation and the machine stops, then an error message will be displayed. To clear
the error, press CLEAR key. The machine will try to solve the problem automatically, but if it fails to clear a jam
or there are some other mechanical errors, open the front or rear cover and get rid of jammed bills and close the
cover correctly. Then press the CLEAR key again to clear error message.
STOP during OPERATION
Press START button to stop operation while the machine is counting.
To restart, press CLEAR button.
To Next Page
Loading...
