SBM SB-9 - Page 8

8
Setting Up Your Machine
Power Cord
Plug one end of the cord into the back of the machine and the other
end into a standard AC power outlet.
If you turn on the power switch, the machine will display version and
checksum. If there is Service Call number saved by a service
provider, the Call number will be displayed.
Printer
Your SB-9 has a serial interface port, which allows you to connect the printer to print out counting result. To
connect the printer to the machine, follow the steps below:
1. Make sure that both the SB-9 and the printer are turned off.
2. Plug the cable of printer into the serial port of SB-9.
3. Turn on the printer and SB-9.
CAUTION
In case that another port is used to avoid
electrical shock, turn off SB-9 and turn on
the machine after Port is connected.
.