IPM25 User Manual
11
Parameter Set-up Information
SEt
OPEr
Press
To skip to next menu item
Press
To select operation mode
This allows the enabling or disabling of the power save mode, which updates at 1 update per
second and pulses the sensor excitation. This results in a lower accuracy (1 part in 20,000).
To enable press
To disable press
AUtO
OFF
Press
To skip to next menu item
Press
To set auto power off
This enables the setting of an auto power off value. The value entered is in minutes. If no front
panel buttons are pressed for the time set here, then the indicator will automatically power off,
to conserve battery life.
Values between 05 and 99 can be entered (00 leaves the IPM25 permanently powered), using
the
and arrows to select a digit and the and arrows to increment or
decrement the digits. Press
to accept the value and move onto the next parameter.
rS232
Press To skip this parameter and exit menu
To Next Page
Loading...
