IPM25
User Manual
3
Introduction
The IPM25 Portable Strain Display Load Cell/Force transducer readout is a microprocessor based portable
instrument designed to interface with any full bridge sensor with an output sensitivity of up to 50mV/V.
Bridge resistances from 85 upwards can be used with the IPM25.
Configuration and calibration of the IPM25 is achieved using the front panel push buttons to navigate
through a very simple menu structure.
User functions available on the IPM25 include:-
Range Selection
Display Hold/Freeze
Gross/Net indication selection
Peak Hold selection
Trough Hold selection
Shunt Cal check
The IPM25 is powered by two internal non-rechargeable AA alkaline batteries.
User Operation
Operation Annunciators
Unit Labels
6 Push Buttons
used for normal
operation and for
configuration
Full 7 digit LCD
display
To Next Page
Loading...
