9
ASSEMBLY
TOOLS NEEDED FOR MOUNTING OF THE STOVE
¬ Spirit level ¬ Open-end spanner
¬ Cutting nippers ¬ 4 mm Allen key
LOOSE PARTS
In the stoves combustion chamber you will find the following loose parts:
¬ 4 pcs. screws for fastening the connecting piece ¬ Seal for the connecting piece
¬ Repair lacquer for coloured stoves ¬ Glove
ADDITIONAL ACCESSORIES
¬ Small shaped floor plate in glass or steel ¬ Large shaped floor plate in steel
(not for corner installation) (not for corner installation)
¬ Large base floor plate in glass ¬ Scan 85-3/4/5/6: Heat accumulating stones
(not for corner installation)
¬ Adjustment key for height adjustment
DISPOSAL OF PACKAGING
Your Scan stove may come supplied with the following packaging:
Wood packaging
The wood packaging can be reused and after final use can be incinerated as a CO
2
neutral
product or sent for recycling.
Foam Send for recycling or waste disposal
Plastic bags Send for recycling or waste disposal
Stretch/plastic film Send for recycling or waste disposal
FRESH AIR INTAKE
In a well-insulated house, the air used up by the burning process has to be replaced. This particularly applies to houses with
mechanical ventilation. There are different ways of making sure that an air exchange takes place. The most important thing is to
ensure that there is a supply of air to the room where the wood stove is located. The external wall vent must be located as close
to the wood stove as possible, and you must be able to close it when you are not using the wood stove.
National and local building regulations must be followed with regard to the connection of fresh-air intake.
To Next Page
Loading...
