#SC 45TW-SS 10 – 110202Page 16 of 40
7. Maintenance
7.1. Preventive Maintenance
In order to keep your Scanjet tank cleaning machine servicing you as an efficient
tool in your tank cleaning operations, it is essential to care for maintenance.
Following a simple maintenance program will keep your tank cleaning machine
in good condition and the machine will maintain its high performance.
The following recommended preventive maintenance program is based on tank
cleaning machines working in average conditions. However, a cleaning machine,
which has a rough and dirty job to do, will need more frequent attention than
one working in ideal conditions. It is recommended that the maintenance
program is adjusted to suit such a situation.
Only use proper tools when servicing the machine; see chapter “16. Tool Kit”
for Scanjet standard tool kit. Never use excessive force or hammer components
together or apart. Always follow all assembly/disassembly steps in the order
described in this manual. Never assemble components without previous cleaning;
this is especially important at all mating surfaces. Work only in a clear well lighted
working area.
Change of bearings is recommended every 250 working hours
Change of gears is recommended every 500 working hours
See next page about “Service Kit”
When re-tightening the screws/bolts use Loctite 243. For other threads
there are instructions about the use of Loctite, read “7.5. Reassembly”
on page 23.
Good maintenance is careful and regular attention!
To Next Page
Loading...
