Scanreco RC400 User Manual

Installation instructions 4 - 6
Doc.nr : 6611-018
4. Next install any ON/OFF functions required. The ON/OFF cable is marked
(; and should
be connected to the "212))" contact on the electronicbox.
• Normal 212))IXQFWLRQ usage is to drive a signal / beep function, throttle lever,
changeover valves, motor start/stop etc. See connection recommendations for the
starting of a motor !
Each 212))IXQFWLRQ can drive a PD[LPXPRI$PSHUH

• The output function is disconnected automatically if loaded by more than $PS, i.e.
the drive output is not damaged.
( For higher output drive an auxiliary relay can be mounted. See connection schematic
for starting of vehicle motor ).
5. Connect the power supply cablesvia the crane emergency stop box to the electronicbox +
supply voltage + and - to ground.
&DEOHQXPEHU9'&PD[9 SHDN  WR  SHDN 0DUNHG
&DEOHQXPEHU9'&*5281'*0DUNHG

&KHFNWKDWWKHVDPHHDUWKSRWHQWLDOH[LVWVEHWZHHQWKH6FDQUHFRHDUWKFDEOH1RDQGWKHYHKLFOHV
EDWWHU\PLQXVGXULQJPD[ORDGLQJLHWKHUHLVQRWDSRWHQWLDOGURSGLIIHUHQFHDVDUHVXOWRISRRU
HDUWKLQJRUWKHFDEOHFURVVVHFWLRQDODUHDEHLQJLQVXIILFLHQW

Standard car type fuses are located inside the electronicbox.3OXVIXVH$PSDQGPLQXVIXVH
$PS$XWRPDWLFIXVHVPD\127EHXVHG
LQWKHHOHFWURQLFER[

Use supply cable with the correct dimension (PLQPP
 )
, so that the cable bushings in
the crane emergency stop box seal properly. Make sure that all cable terminals are well
tightened.


)RUEDFNHQGPRXQWHGFUDQHV Use supply cable ofPLQPP

! ! !
8VHSOHQW\RIJUHDVH in the emergency stop breaker and its screws and the supply cable.
Connect power from the vehicle battery via the vehicle’s ignition switch or power outlet.
:DUQLQJ Volvo trucks which break main power on the HDUWKVLGH ( not the plus side ) :
Make very sure that the electronicbox earth is connected correctly, i.e. that the earth for the electronicbox
is also disconnected !!
hydrostat.ru

Scanreco RC400 Specifications

General

Category	Remote Control
Model	RC400
Operating Temperature	-20°C to +55°C
Power Source	Battery
Protection Class	IP65