SCARAB M6 SWEEPER KIT
17 Operator’s Manual Amdt. 1 - 03 November 2009
USING THE REAR-MOUNTED WANDER BOOM
The rear-mounted wander boom arrangement is permanently fitted and,
when required, can be used while sweeping. The weight of the hose/
nozzle is supported by a gas strut attached to the boom assembly. The
system incorporates a manually operated blanking flap.
For situations requiring maximum suction power, such as when clearing gully
pots, blank off the suction nozzles (See Para. 1.).
1. Deselect any active suction nozzle(s). This will close their
nozzle blanking flap(s). The switch LED will extinguish.
2. Demount t
he hose assembly from its stowage as detailed at
Fig. 6 and swing-out the entire assembly t
o the required position.
3. Open the
blanking flap. The wander boom is now ready for use.
Fig. 6 The Rear-Mounted Wander Boom & Blanking Arrangement
SUCTION HOSE OMITTED TO AID CLARITY
CLOSE OPEN
WANDER BOOM
GAS STRUT
SUCTION TUBE
CONTROL YOKE
BLANKING FLAP
BOOM STOWAGE
HOOK
SUCTION TUBE STOWAGE
SHOWN OPEN
Right Hand Drive vehicle shown.
The assembly is fitted to the opposite side on Left Hand Drive machines.
To Next Page
Loading...
