- 17 -
www.SCEPTRE.com
SCEPTRE C27 FHD Display User Manual
If You h
1. Make sure the power of C27 LED MONITOR is turned off.
2. If you were previously using a CRT (bulky) monitor, please hook up your old monitor
first and make sure your refresh rate is set to 75 Hz frequency before using the C27 LED
MONITOR. You can find the refresh rate information and change it by RIGHT CLICKING
on the desktop with nothing selected. After you have right clicked, select the
PROPERTIES option. Click on the SETTINGS tab. Click on the ADVANCED button.
Click on the MONITOR tab. In that tab, change the refresh rate to 75 Hz and click on
APPLY. After the refresh rate changed, please shut down the computer and monitor.
3. Obtain the VGA cable and connect to the VGA connection on your PC. Connect the
other end of the cable to your C27 LED MONITOR.
4. Turn on the power of both the C27 LED MONITOR and the PC.
Please Note:
ture is ran with 1920 x1080 at 75 Hz.
If the VGA port receives no signal for over 1 hour, the monitor will auto shut-
off.
To Next Page
Loading...
Need help?
General
