What to do if my Sceptre E27 screen says no signal?
If your Sceptre Monitor displays no LED or shows a 'No Signal' message, ensure you've selected the correct source. Verify the video signal is present on both sources. Inspect your video cable for damage and try swapping it with a new one. Also, check that the power plug is securely connected to both the monitor and the wall outlet.
How to fix incorrect resolution on Sceptre Monitor?
If you cannot get the correct resolution on your Sceptre Monitor, rebooting your computer might solve the problem. The issue might be that your video card is not reading the monitor correctly. Also, ensure that your video card drivers are up to date.
How do I reset my Sceptre E27 Monitor?
To reset your Sceptre Monitor, ensure it has a valid video signal. Press the menu button to open the OSD (On-Screen Display). Look for the 'RESET' option under the 'SYSTEM' menu.
Why is my Sceptre E27 Monitor too bright?
If the video on your Sceptre Monitor is too bright even after adjustments, try lowering the contrast and increasing the brightness to compensate. This issue might occur because newer LCDs with HD video capability may not be fully compatible with older video cards.
Why are the colors not correct on my Sceptre Monitor?
If the colors on your Sceptre Monitor are not displaying correctly, the issue might stem from a loose or faulty DVI, DP, or HDMI cable. Try reconnecting the cable securely. If the problem continues, replace the current cable with a new one to see if it resolves the color issue.
Why are the words blurry on my Sceptre E27?
If the words and video appear blurry on your Sceptre Monitor, ensure you are using the monitor's native resolution of 1920 x 1080 at 60Hz. If the problem persists, try enabling or disabling the CLEAR TYPE function in Windows.
How to reset color settings on Sceptre E27?
To restore the factory default settings on your Sceptre Monitor, open the OSD (On-Screen Display), navigate to 'SYSTEM,' and select 'RESET'. This will reset all settings to their original factory values.
How to make words bigger on Sceptre E27 Monitor?
If the words appear too small on your Sceptre Monitor at the native resolution of 1920 x 1080, you can adjust the text size within the Windows Operating System through its display properties.
How to get higher refresh rates on Sceptre Monitor?
If you cannot achieve higher refresh rates on your Sceptre Monitor, verify that your video card supports the desired refresh rate. Also, ensure you are using an HDMI connection from your computer to the monitor.
What to do if my Sceptre Monitor says “Signal Out of Range”?
If your Sceptre Monitor says “SIGNAL OUT OF RANGE”, and you have a CRT monitor, connect it to the computer and lower the refresh rate to 60 Hz via your video card’s display settings. If you don't have a CRT monitor or it's broken, turn off both the monitor and your computer. Turn them back on, and as the computer starts, repeatedly press the “F8” key until a selection menu appears. Choose the “Safe Mode” option. In Safe Mode, uninstall any video card and monitor drivers using “Add / Remove Programs” or through “System Properties”, removing entries under “Monitors” and “Display Adapters”. Reboot your computer, reinstall the monitor driver first, then the video card driver, ensuring the refresh rate is set to 60Hz.
General| Screen Size | 27 inches |
|---|---|
| Refresh Rate | 75Hz |
| Response Time | 5ms |
| Brightness | 250 cd/m² |
| Aspect Ratio | 16:9 |
| Ports | HDMI, VGA |
| Contrast Ratio | 1000:1 |
| Color Gamut | 72% NTSC |
| Resolution | 1920 x 1080 (FHD) |
| Viewing Angle | 178° (Horizontal/Vertical) |
To Next Page
